opkparadise.blogg.se

Solid state drive for macbook pro early 2011
Solid state drive for macbook pro early 2011












solid state drive for macbook pro early 2011

  • Also remove the transparent plastic tab.
  • Use the Torx T6 tool included with the Data Doubler to remove the 4 Torx T6 screws on the side of the hard drives.
  • Make sure to detach the SATA Power and Data connector carefully.
  • Use the transparent strip on the Hard drive to pull out the hard drive from the hard drive area.
  • Remove the retainer bar held in place by two black screws that is holding the installed hard drive in place.
  • Disconnect the battery connector from the motherboard (logic board) with the nylon tool.
  • Replacing the Hitachi 500GB 7200RPM Hard Drive with the OWC Mercury EXTREME Pro 6G SSD
  • Gently lift the cover off the MacBook Pro.
  • Remove all the screws starting with the longer screws.
  • There are 10 small Phillips screws that need to be removed, three longer Phillips screws on the top right hand side of the MacBook Pro.
  • Turn off your MacBook Pro, close it and turn it upside down.
  • Opening up the Apple MacBook Pro 15″ Early 2011 Model














    Solid state drive for macbook pro early 2011